Please refer to the programming guide to set the scanner to Auto discriminate UPC/EAN/JAN Supplemental.

The command can not be sent via serial/USB COM. To send commands to turn on/off scanner triggering, please set the interface to "Symbol Native API" for USB interface or "SSI Host" for RS232 interface with Quick Guide. Then you can send command with SDK.

Please use the following barcodes to enable reading for inverted barcodes.

Inverse 1D

Data Matrix Inverse

QR Inverse

Aztec Inverse

In presentation mode, selecting Enable Low Light Enhancement causes illumination to remain on at a low power in low lighting conditions. When the engine detects an object in its field of view, it turns on illumination full power. Select Disable Low Light Enhancement to prevent illumination from remaining on under low lighting conditions.

Yes, please do the below setting and run the tool. 

1. Set scanner with the barcode below

    For USB interface

  For RS232 interface

2. Execute KeySimulator

To capture a picture, the 2D scanner needs to be set to "Symbol Native API (SNAPI) with Imaging Interface" for USB device type or "SSI Host" for serial device type. An application with SDK programmed to capture the Image is also required. To read barcodes, you can use Keysimulator to transmit data to Notepad and Word.

If you use virtual COM port emulation, follow the steps below to start using the scanner.
1. Execute the CDC Driver(x64).
2. Connect the scanner USB cable to the host computer. The scanner would give a
"Do Re Mi" melody when powered on. .
3. Read the CDC COM Port Emulation barcode at right to set up interface.
4. On the computer, check Device Manager to see if the computer successfully detects
the scanner as “Symbol Bar Code Scanner.” (The COM port number would vary

The 2D scanner can not be set to HID mode when using a serial cable. You can work around it, however, by setting the scanner to "SSI Host" and use keysimulator to transmit barcode data to Windows Notepad or Windows Word in text mode

Please execute the USB virtual-COM driver and re-plug the 2D scanner to the PC. Check again to make sure the COM port is assigned in Device Manager.

Please refer to the programming guide to set the scanner to Presentation Mode

Please refer to the user's manual to set the scanner to barcode value: Prefix → 1 → 0 → 0 → 9 → <PREFIX> <DATA> <SUFFIX 1>

The minimum Data Matrix code element size is 12 mil.

Yes,it can support to transmit the characters.  

To capture a picture, the Z-3152 needs to be set to "Symbol Native API (SNAPI) with Imaging Interface" for USB device type or "SSI Host" for serial device type. An application with SDK programmed to capture the Image is also required. To read barcodes, you can use Keysimulator.exe to transmit data to Notepad and Word.