Mostly the PS/2 scanner is accompanied with a Y cable, when you remove original PS/2 keyboard from system and install PS/2 scanner instead. You have to connect PS/2 keyboard to the other PS/2 port on the Y cable.
If you use a USB keyboard but PS/2, please set the scanner to keyboard stand-alone mode as below.
1.
2.
3.
When the scanner is able to read the barcode the problem may be caused by the incorrect host interpretation of the USB protocol. Please use the following setting codes to adjust the USB speeds.
．USB0: Regular speed mode. Usually for older operating systems like Windows 98 when default setting is not working.
．USB1: Full speed mode. The default speed of the scanner.
．USB2: Middle speed mode. Usually for Mac O.S. or Linux O.S when default setting is not working.
Please follow the steps below and refer to the Programming Guide to set the minimum or maximum length.
Normally the quiet zone has to be observed as necessary when making the barcodes.
If barcodes have been made. Please refer to the margin settings and try to set the margin smaller to see if able to correct the problem and output normally.
Please refer to the programming guide to set the EAN/UPC "Add on 2 or 5" for the scanner.
1.
2.
3.
Start → Reset → End for new ISBN =EAN-13.
1.
2.
3.
Start → RC11 → End for old ISBN.
1.
2.
3.
Please refer to the programming guide to set the scanner to barcode value: Start→UE66→UE18→UE28→End.
1.
2.
3.
4.
5.
Please refer to the user's manual to set the scanner to barcode value:
1. Start of Configuration.
2. Keyboard terminator---H-TAB.
or RS-232 message terminator—H tab
3. End of Configuration.
Please refer to the user's manual to set the scanner to barcode value: Start → HT02 → F7→ SET → CP05 → End.
1.
2.
3.
4.
5.
6.
If the barcode type is EAN-13, please set EAN-13 country code first:"0" can't transmitted.
1.
2.
3.
The present handheld scanner can only be set to scan the first 6 numbers for all barcode including Code 128.
Please do the settings as below.
Please refer to the user's manual to set the scanner to barcode value:
(CP21) Alphabet always upper case.
1.
2.
3.
Please refer to the programming guide.
For example (1D scanner) : Set the scanner to barcode value: Start → HT01 → $ → SET → End.
The factory default of scanner has 1 Enter. Please refer to the programming guide to set the scanner to barcode value: Srart →CP05→HT02→CR→SET→End .
